Exlar GSM20, Инструкция по установке и обслуживанию

Страница: 13 / 35

Curtiss-Wright | GSM Series Rev. U PN29959 3/28/17 13
6
Protected against high pressure water jets from any
direction. Limited ingress permitted.
7
Protected against short periods of immersion in water of 1m
or less for 30 minutes or less.
8 Protected against long durations of immersion in water.
9 High-pressure, high-temperature wash-down applications.
Suffix
S Device standing still during operation
M Device moving during operation
3.0 INSTALLATION AND OPERATION
3.1 Lubrication Requirements
The GSM Series actuator is shipped from the factory fully greased
and ready for installation. Exlar recommends using Mobilith SHC 220,
a high performance, extreme-pressure grease. The unique physical
properties of the synthetic base oil provide outstanding protection against
wear, rust, corrosion and high or low-temperature degradation. Mobilith
SHC allows for very low starting and running torque values. Its operating
range is -40° C to 177° C (-40° F to 350° F).
3.2 Mounting Configurations
The standard configurations available are Rear Clevis, Front Flange,
Extended Tie Rods, Side Trunnions and side tapped mounting holes.
General drawings are shown in the product section guide.
3.3 Mounting Considerations
Every effort should be made to minimize misalignment. Any
misalignment will decrease the life of the components within the actuator
and also may create problems within the application associated with
misalignment.
Excessive side load on the output rod of the actuator will
dramatically reduce the life of the actuator and should be
avoided completely. Side load can be caused from
misalignment or loading that is not inline with the actuator
output rod.