RME1-TC User’s Manual - Thermocouple Acquisition Module
Exemys
2.4.1 Hub or Switch connection
To connect the RME1-TC to Ethernet through a Hub or Switch, it is necessary to use a straight-
through UTP network cable.
Rx+ (1)
Rx- (2)
Tx+ (3)
Tx- (6)
Rx+ (1)
Rx- (2)
Tx+ (3)
Tx- (6)
Figure 8 - Straight-through cable scheme
Rx + (1)
Rx - (2)
Tx + (3)
Tx - (6)
1
8
Figure 9 - RJ45 connector
2.5 Analog inputs description
In Figure 10 it can be seen where the RME1-TC analog terminals are placed. The inputs are in
columns on both sides of the device
The inputs start numbering from 0. So that the first channel is CH0.The same way, each terminal
is numbered for its function and the channel it belongs to. So, the RME1-TC first terminal in
Channel 0 is called (PTO-), meaning: negative terminal of the thermocouple.
www.exemys.com Rev.
1
Page
12
