29
Technical Specifications
w w w . t e c n a r e . c o m
T Series | rev.:1.1
TANIT
7.
Technical specifications
TANIT ARCUATE LINE SOURCE COLUMN SPECIFICATIONS
Application information is presented for guidance only. Exel Acoustics SL reserves the right to make any necessary changes to
the products and the published specifications. As part of the ongoing development program Exel Acoustics SL tries to maintain the
highest degree of product compatibility
ACOUSTICAL
Operating Frequency Range
75 Hz - 20 kHz ±3dB, measured on axys. 90Hz-18kHz Recommended operating frequency range.
Response depends on loading conditions and room acoustics
Axial Sensitivity
98 dB (1w/1m)
Calculated SPL
128 dB continuous/134 Peak
Nominal Dispersion
Asymetric: horizontal 120º; vertical: 35º (+10/-25)
Nominal impedance
6 ohm
COMPONENT
Low Frequency
6 x 5-inch custom made cone drivers neodymium magnets, direct radiation, bass-reflex
Nominal impedance: 8Ω/loudspeaker
Voice coil size: 38 mm / 1.5-inch
Power Handling Capability: 150 W AES / 300 W continuous / loudspeaker
Note:
Power Handling measured using AES Standards= 2 hours test made with continuous pink noise signal
(6 db crest factor) from the recommended xover point. Power on Continuous Program is defined as 3 dB
greater than the Nominal rating
High Frequency
2 x 1-inch neodimium magnets motor - compression driver
Nominal impedance: 16Ω/driver
Voice coil size: 38 mm / 1.5-inch - keton polymer diaphragm
Power Handling Capability: 35 W AES / 70 W continuous
Note: Power Handling measured using AES Standards= 2 hours test made with continuous pink noise signal
(6 db crest factor) from the recommended xover point.Power on Continuous Program is defined as 3 dB
greater than the Nominal rating
AUDIO INPUT
Connectors
IN: 1 x NL4 SpeakON®
LINK: 1 x NL4 SpeakON®
IN: Autoconnect at bottom
Wiring
Pin 1+/-: LF+/- ; Pin 2+/- :N.A.;
PHYSICAL
Enclosure
16 mm birch plywood. Finished in Polyurea surface
Protective Grille
Black Powder-coated hex-stamped perforated steel with acoustically transparent black fabric
Fitting
13 x M8 integrate insert for rigging accessories. One recessed carrying handle on the back. One M8 insert
for safety.
Dimensions (HxWxD)
1274,5mm x 162,5mm x 230,3mm (50,18” x 6.40” x 9.07”)
Weight
23 Kg. (50.7 lbs)
