Excelitas Technologies X-Cite 200DC, Руководство пользователя

Страница: 14 / 50

10
X-Cite
®
200DC User Guide
035-00446R rev. 4
5 Installation/Set-up
5.1 Installing Lamp Module
5.1.1 Be sure the AC POWER cord is disconnected from the unit.
5.1.2 Remove the screw from the lamp housing side panel using the 3mm hex tool
provided and remove the panel from the unit cover.
Figure 3 Side Panel
5.1.3 Carefully remove the lamp module from its container, holding only the ceramic
component and lamp rim.
5.1.4 As illustrated below, position the lamp facing towards the front of the unit with the
POWER leads facing towards you. The lamp should be aligned so that the
leading edge of the reflector (lamp rim) fits into the mounting groove on the lamp
holder assembly.
Caution!
The lamp module’s operational life can be significantly shortened if
handled incorrectly. Be sure only to handle the ceramic surfaces and
the lamp rim. Do not touch the bulb’s glass envelope or the inside
surface of the reflector. Skin oils can cause the lamp module to fail
prematurely.
LAMP HOUSING
SIDE PANEL
Note: Review Section 2
– Safety Precautions before proceeding