E X C E L D R Y E R , I N C 1 . 4 1 3 . 5 2 5 . 4 5 3 1 1 . 8 0 0 . 2 5 5 . 9 2 3 5 ( U S / C N ) E X C E L D R Y E R . C O M
A D M I N @ E X C E L D R Y E R . C O M 3 5 7 C H E S T N U T S T R E E T, E A S T L O N G M E A D O W, M A 0 1 0 2 8
2 / 2 0 2 1
1
ThinAir
®
HAND DRYER
INSTALLATION AND OWNER’S MANUAL
Dryer Model
Serial Number
Date Of Purchase
Hand Dryer
Installation and Owner’s Manual
CONTENTS OF BOX
1
2
3
MODEL INFO
EN
CLEANING / MAINTENANCE
Disconnect power to the dryer before cleaning. It is recommended that you
refer to the WHO or CDC for handling guidelines when cleaning the Pre-Filter or
replacing the HEPA filter if either may have been exposed to a contagion.
OUTSIDE:
Gently wash Cover (including air inlet holes) using a soft cloth
or sponge and a mild soap or detergent with lukewarm water to
loosen dirt and grime.
INSIDE:
It is recommended to inspect the inside of the dryer and clean
at least twice per year. Excessive lint, dust or other particles in
the air may require more frequent cleaning. Lint on the air inlet,
the dryer Pre-Filter, HEPA filter (if so equipped) or other internal
parts of dryer will reduce efficiency and shorten the life of the
working parts.
TO CLEAN:
Use the Tamper-Proof Wrench supplied and remove the Tamper-
Proof Bolt on bottom of cover, lifting upwards to remove cover
from base plate. Gently clean all parts using a small soft brush.
Remove the PreFilter, rinse with water and dry. Inspect the
HEPA Filter (if so equipped) for any excessive debris buildup
whenever the Pre-Filter is removed. DO NOT CLEAN THE
HEPA FILTER OR ALLOW IT TO COME INTO CONTACT WITH
WATER. Reinstall the Pre-Filter, cover and restore power.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the manufacturer.
B. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
C. For proper electrical connections, check your local building codes. Your unit must be installed by a qualified,
licensed electrician
MOUNTING DETAILS
R E A D A N D S AV E T H E S E I N S T R U C T I O N S
Tamper-Proof Wrench
Knockout Gasket
(included
for use with Model TA-ABS only)
MODELS:
TA -
WITH OR WITHOUT SUFFIX
AND/OR
ABS
GR
SI
SB
SP
W
V
K
H
