ITEM
#EX-21BS
A
B
C
D
E
F
J
G
H
I
X 24
X 32
X 28
X 4
6
B
D
5
www.general.ca
EX-21BS_V4_R2 - 07-01-2015 © COPYRIGHT GENERAL INTERNATIONAL
4.
Attach a long tie bar
D
with it’s edge sitting over
the short tie bar edge as shown in
5
, then attach
the second long tie bar.
5.
Attach the two top long shelves
B
, with their
edges sitting over the top short shelf as shown
in
6
.
1
C
E
4
2
CLOSE UP VIEW
CLOSE UP VIEW
CLOSE UP VIEW
3
1.
Attach an adjustable leg extension
F
to each leg
A
using two carriage bolts with washers and nuts
1
, as shown.
Note: Select the hole 3 that comes closest to the desired
height for your saw.
2.
Attach one top short shelf
C
and short tie bar
E
to
one leg as shown, then attach a second leg,
4
.
3.
Repeat with the second pair of legs.
Note: Position the legs
with the holes for the
lower tie bars closer to
the bottom
2
.
FOR EXCALIBUR EX-16 & EX-21 SCROLL SAWS
Adjustable height stand
24 1/2” to 31 1/2”
F
A
UNPACKING
NOTE: Please report any damaged or missing items to your
General International distributor immediately.
LIST OF CONTENTS
QTY
A-
LEGS ................................................................................................. 4
B-
LONG TIE BAR .................................................................................. 2
C-
SHORT TIE BAR ................................................................................. 2
D-
TOP LONG SHELF ............................................................................. 2
E-
TOP SHORT SHELF ............................................................................ 2
F-
ADJUSTABLE LEG EXTENSION ......................................................... 2
G-
CARRIAGE BOLT
(for stand assembly) ...................................... 24
H-
WASHER ......................................................................................... 32
I-
HEX NUT ......................................................................................... 28
J-
HEX BOLT (to attach scroll saw to stand) .................................... 4
ASSEMBLY INSTRUCTIONS
Note: Do not fully tighten the stand bolts until after you have fastened the scroll saw to the stand.
