REMEMBER THE FOLLOWING WHEN USING THE Exact AIR 360
1.
Do not let the air motor run unloaded. Start the cutting process immediately
after switching on the air motor.
2.
A maximum pressure of 6.3 bar (90 PSI) is required to obtain full power.
3.
A maximum free air volume of 3.9 m
3
/ min is required to obtain full power.
4.
NOTE: If you do not have the maximum pressure or air flow, the lower power will
slow the working speed.
5.
The compressed air purity requirement is 40 microns / m
3
or better.
6.
The compressed air must be dry.
7.
Check the condition of the hose.
8.
Check the blade tightness before cutting; blades may loosen in cold conditions.
9.
If the motor runs only momentarily after the Start button has been pushed, there
is not enough oil. NOTE: Push the piston in the oil tank downwards and add oil.
A red mark on the piston indicates its movement.
10.
Make sure that the oil tank has enough oil at all times.
GENERAL
1.
Blade 180 mm or 165 mm (7” or 6.5”).
2.
Max no-load speed 4000 rpm.
3.
Air intake and exhaust couplings ¾ NPT inside thread.
4.
Operating tempe 40°C – –20°C / 104°F – –4°F.
5.
Check tightness of saw blade.
6.
Check condition of air hoses and couplings.
RECOMMENDED MOTOR LUBRICATION OIL MOBIL DTE 24 ISO VG32
The temperature range of this oil is +5°C to +40°C (41°F to 104°F).
If the temperature is lower than +5°C (41°F), a thinner oil must be used.
REMEMBER
When starting the motor, a lubricator squirts oil into the motor. When the oil tank is
almost empty, the motor will only run momentarily when the Start button has been
pushed. Every time you push the Start button, the lubricator will squirt oil until the
oil tank is completely empty. In practice, this means that there will be a substantial
amount of oil coming from the exhaust coupling.
www.exacttools.com
EXACT AIR 360 QUICK REFERENCE