Exabyte 221L, Руководство по эксплуатации продукта

Страница: 61 / 208

A
UGUST
2005 E
XABYTE
221L
AND
221L-FC L
IBRARIES 45
S
ETTING
C
ONFIGURATION
O
PTIONS
4.
4. 4.
4. Press the down arrow key to display “Clean Slot Option,” then press
[ENTER]
.
The Clean Slot Option screen shows which slot is designated as the
cleaning slot (21 in the example below) and whether the option is on (1) or
off (0)
.
5.
5. 5.
5.
Press
[ENTER]
.
The following screen appears.
6. 6. 6. 6. Press the up or down arrow key to select “1” to turn the fixed cleaning slot
option on or “0” to turn it off, then press
[ENTER]
. The screen shows the
current selection.
Setting the Number of Cleaning Cycles
The Cleaning Tape Cycles Left option is a counter that tracks the number of
times a cleaning cartridge has been used. When you install a new cleaning
cartridge, you must use this option to set the number of cleaning cycles that
remain. After completing a cleaning cycle, the library automatically decreases
the Cleaning Tape Cycles Left counter by one.
Note: Refer to the information provided with your LTO Ultrium cleaning
cartridge to determine how many cleaning cycles it contains.
To set the Cleaning Tape Cycles Left option:
1.
1. 1.
1. If the security option has been enabled, disable it (see page 50 ).
2.
2. 2.
2. If necessary, press
[MENU]
to display the menus. Press the down arrow key
until “Config Menu” appears, then press
[ENTER]
.
3. 3. 3. 3. Press the down arrow key to display “Cleaning Tape Cycles Left.”
4.
4. 4.
4. Press
[ENTER]
. The following screen appears.
5. 5. 5. 5. Use the arrow keys to set the number of cleaning cycles that remain on the
installed cleaning cartridge, then press
[ENTER]
.
C l e a n S l o t ( 2 1 )
O p t i o n : 0
C l e a n i n g S l o t a t
S l o t 2 1 ? 0
↑
C l e a n i n g T a p e
C y c l e s L e f t : 1
C l e a n i n g C y c l e s
L e f t ? 1
↑