Design and function
Special parameters (advanced settings)
78
099-005407-EW501
8.2.2022
Display
Setting/selection
Predefined absolute value for relative programs
Start program (P
START
), down-slope program (P
B
) and end program (P
END
) can be set re-
lative to the main program (P
A
) or in an absolute manner, as desired.
0 = ------- Relative parameter setting (ex factory)
1 = ------- Absolute parameter setting
Electronic gas flow control, type
1 = ------- type A (ex works)
0 = ------- type B
Program settings for relative programs
0 = ------- Combined setting of relative programs possible (ex works).
1 = ------- Individual setting of relative programs possible (ex works).
Correction or nominal voltage display
0 = ------- Correction voltage display (ex works).
1 = ------- Absolute nominal voltage display.
JOB-Selection with Expert operating mode
> see 5.11.3.23 chapter
0 = ------- SP1-SP3 Switching on the wire feeder if the machine has an expert control (ex
works)
1 = ------- JOB selection of wire feeder possible
Nominal value of wire spool heater (OW WHS)
> see 5.11.3.24 chapter
off = switched off
Temperature setting range: 25°C - 50°C (45°C ex works)
Operating mode switching at welding start
> see 5.11.3.25 chapter
0 = ------- Not enabled (ex works)
1 = ------- Enabled
Error threshold of electronic gas flow control
> see 5.11.3.26 chapter
Error output in case of gas nominal value deviation
Unit system
> see 5.11.3.27 chapter
0 = ------- metric system (ex works)
1 = ------- Imperial system
Selection option for program sequence with rotary knob
> see 5.11.3.28 chapter
0 = ------- Not enabled
1 = ------- Enabled (ex works)
5.11.2 Reset to factory settings
All special parameters saved by the user will be overwritten by the factory settings!
l
0
l
0
Figure 5-71
