Design and function
General
099-008197-EW501
12.08.2013
11
5
Design and function
5.1
General
NOTE
Basically, all descriptions on the process settings in the standard operating
instructions shall apply. This operating manual exclusively describes deviating control
functions.
5.2
Connecting the remote control
CAUTION
Damage to the machine due to improper connection!
The remote controls have been developed to be connected to welding machines or wire
feed units only. Connecting them to other machines may cause damage to the
machines!
• Observe the operating instructions for the welding machine or wire feed unit!
• Switch off the welding machine before connecting!
NOTE
Observe documentation of other system components when connecting!
• Switch off the welding machine
• Insert the male connector plug (socket) into the remote control connection socket and lock by turning
to the right.
• Insert the male connector plug (pin) into the remote control connection socket of the welding machine
and lock by turning to the right.
5.3
Basic settings
• Preset the maximum welding current required for the welding task on the welding machine, set the
welding parameters for the welding task correspondingly, and ensure that the unit is set to TIG
welding.
5.4
Standard Mode
Operating
element
Action
Result
Set a reduced welding current
Set alternating current frequency
Set the alternating current balance