Design and function
Inserting the wire electrode
099-005084-EW501
22.09.2011
35
NOTE
The welding wire is fed into the rear groove on the wire roll!
• Labels relate to the rear groove on the wire roll when installed.
Figure 5-10
5.9.3
Inching the wire electrode
CAUTION
Risk of injury due to moving parts!
The wire feed units are equipped with moving parts, which can trap hands, hair,
clothing or tools and thus injure persons!
• Do not reach into rotating or moving parts or drive components!
• Keep casing covers closed during operation!
Risk of injury due to welding wire escaping in an unpredictable manner!
Welding wire can be conveyed at very high speeds and, if conveyed incorrectly, may
escape in an uncontrolled manner and injure persons!
• Before mains connection, set up the complete wire guide system from the wire spool to the
welding torch!
• Remove the pressure rollers from the wire feed unit if no welding torch is fitted!
• Check wire guide at regular intervals!
• Keep all casing covers closed during operation!
