Operating the machine control
Offline data transfer (USB)
099-00L104-EW501
17.01.2022
31
5.4.7.4 Errors and warnings
A list of all ewm Xnet-specific errors and warnings are displayed with their ID number and description.
5.4.7.5 Status information
Figure 5-8
5.4.7.6 Network
Figure 5-9
5.4.7.7 Clear system memory
Resets the internal system memory used for saving welding and log data and deletes all data.
All welding data recorded so far, which have not been transferred to the Xnet server via flash
drive or network connection, will be permanently deleted.
5.4.7.8 Reset to factory settings
All machine configuration data relating to Xnet will be reset to the factory setting. The system memory
data will not be affected, i.e. any welding or log data recorded will be saved.
5.5 Offline data transfer (USB)
You may only use this USB interface to exchange data with a USB flash memory. You must not
connect any other USB devices such as keyboards, hard disks, mobile telephones, cameras or
other devices so as to avoid any damage tp the machine. The interface does not provide any
load functions either.
