Design and function
Assembly/disassembly
099-008593-EW501
26.07.2019
11
5
Design and function
WARNING
Risk of injury from electrical voltage!
Contact with live parts, e.g. power connections, can be fatal!
• Observe the safety information on the first pages of the operating instructions!
• Commissioning must be carried out by persons who are specifically trained in handling
power sources!
• Connect connection or power cables while the machine is switched off!
Read and observe the documentation to all system and accessory components!
5.1 Assembly/disassembly
WARNING
Risk of accidents due to screw connectors that are not locked!
Attention must be paid to cleanliness and correct installation
when mounting a power source with a cooling module. The coo-
ling module could become loose if not properly mounted, thereby
causing serious injuries.
• Remove dirt from the feet of the power source's unit and the screw
connectors of the cooling module before mounting.
• Check that the connections are locked in place before each trans-
port
(push the screw connections back in as far as they will go)!
Assembly and disassembly is very simple and doesn't require any tools.
Figure 5-1
• Open out all four screw connectors on the cooling module as far as they will go.
• Position the welding machine precisely with the machine's feet in the openings of the screw connec-
tors provided on the cooling module.
• Push all four screwed connectors back in as far as they will go.
5.1.1 Connecting the supply lines
Control and supply lead to the welding machine
The cooling module and welding machine are connected using two leads.
• Insert the control lead plug on the welding machine.
• Insert the power supply lead plug on the welding machine.
