Audio-Phase
If this setting is set to Align (default), the card ensures audio-phase alignment
between multiple audio channels and audio groups, which is necessary for
multi-channel (surround) purposes. If errors in the signal-chain occur, the de-
embedder blocks reset synchronously to maintain audio-phase alignment.
If this setting is set to Off, the card eats all audio, including errors. Even if there
are DBN/ANC/ECC or channel-sequence errors, the de-embedder will pass
them. Be aware that audio-phase alignment between multiple audio channels
and audio groups cannot be maintained if this setting is switched off.
Audio_Ctrl
With this setting you select how the audio presets should be controlled. Can be
either Manually (Manual), via GPI-triggers (GPI, GPI-A, GPI-B or GPI-C), via the
SD aspect ratio (SD-AR) or via the HD aspect ratio (S2016).
Audio_Prst_Act
With this item you can manually change the currently active audio preset. Can
be any preset between 1 and 16. By default it is set to 1. All menu settings that
are preceded by the #Emb prefix are part of the preset.
Audio_Prst_Edit
Here you can select which of the 16 selectable audio presets you want to edit.
Changing this will not change the active preset, unless you have selected to
edit the currently active preset. All menu settings that are preceded by the
#Emb prefix are part of the preset.
#Audio-Dly-sInp1
(GXG110 only)
With this item you can delay all audio on input 1 between -10000ms and
10000ms with 0.01ms increments, allowing for precise control (2 sample
accuracy in practice). Default is 0ms. This item is part of the audio presets. This
audio delay is calculated on top of the tracked video delay.
#Audio-Dly-sInp2
(GXG110 only)
With this item you can delay all audio on input 2 between -10000ms and
10000ms with 0.01ms increments, allowing for precise control (2 sample
accuracy in practice). Default is 0ms. This item is part of the audio presets. This
audio delay is calculated on top of the tracked video delay.
5.10.
Embedder
Setting
Description
#EmbA_Grp
With this setting you select into which audio group (= 4 audio channels) of the
outputs you want to embed the first 4 forwarded audio channels coming from
the de-embedders/add-on bus. Can be group1, group2, group3 or group4.
You can also choose to not use these 4 audio channels for anything by setting
this item to off. By default it is set to Group1.
#EmbA1_Inp ~
#EmbA4_Inp
With these settings you can select where the corresponding audio channels
(channel A1 till channel A4) of the outputs are coming from. In this card you
can choose to get the audio from the de-embedder of SDI input 1 (Demb-SDI1)
or SDI input 2 (Demb-SDI2), the embedder of the active input (Demb-Input,
dependent on the current active input), from the ADD-ON bus groups, or to
mute the corresponding channel (set to off). Defaults here are Off.
28
| November 2021 | Issue 1.00.D
