EVS Synapse GED100, Руководство пользователя

Страница: 17 / 74

5. Settings Menu
5.1. Introduction
The Settings menu displays the current state of each GED100 setting and allows you to change or adjust
it.
Settings can be changed using the front panel of the Synapse frame (SFR18, SFR08 or SFR04) or with
Cortex. The SCP08 control can also be used. Please refer to "Quick Start" on page 3 for information on
the Synapse front panel control and Cortex.
5.2. Video
Setting Description
Input-Select With this setting you can select which SDI input you would like to use for
Dolby processing. You can choose between SDI1 or SDI2. Can also be set
to Auto, which automatically chooses the valid SDI input (with SDI 1 as
priority).
Switch-Back When Input-Select is set to Auto and SDI1 fails, the card will
automatically switch to SDI2. When the setting Switch-Back is set to On,
the selected input is set back to SDI1 when SDI1 is valid again. When set
to off, it will remain on SDI2 until it is changed manually or when SDI2
fails.
Lock-Mode With this setting you select what the card should lock itself to: SDI1, SDI2,
Ref1 or Ref2. When set to Ref1 or Ref2 (i.e. one of the frame’s reference
inputs), there will be an autophaser active for the audio, but not a
framesynch for the video! Can also be set to Auto-SDI, which locks to the
currently selected SDI input. Default is SDI1.
Out-Frmt With Out-Frmt you can set what the output should be. This setting is only
used for the delay options. This will not up/down/cross convert your
input signal. Possible settings are:
• 1080i60 • 1080i50
• 1080p60 • 1080p50 • 1080p30
• 1080p25 • 1080p24
• 720p60 • 720p50
• SD525 • SD625
• Auto (default), sets the output format automatically according to
what has been detected).
INSTALLATION AND OPERATION MANUAL
Synapse GED100 | 5. Settings Menu | 9