EVS Synapse 2GF100, Инструкция по установке и эксплуатации, Страница: 21 / 50

5.3. Inserter
This card can insert several data values in the VBI of the outputs. With the following settings you can
choose what you want to insert.
SMPTE ST 352 Video Payload Identifier
The SMPTE ST 352 Video Payload Identifier, also known as VPID, is transported within the ancillary data
of an SDI stream. The ancillary packet is placed in the HANC space. This packet contains 4 bytes of
data.
There are two versions of the standard. The first was published in 2011 and the second in 2013. The
revision can be seen within the 4 bytes.
When the 2GF100 is not processing the incoming VPID packets, they will be passed transparently. When
it generates the packets, the 2GF100 will output VPID packets using the 2013 standard.
Setting Description
S352_Insert S352_Insert enables the Video Payload Identifier insertion in the HANC
space. It enables the user to insert or passthrough (On) the S352 Dynamic
range and colorspace payload. When this menu item is set to On (default), it
will generate a SMPTE ST352-2013 packet and overwrite the existing one
(for both Luminance and Chrominance).When it is set to Off, it will pass the
packet to the output as-is (only on Luminance).In HD 1080i for ATC-LTC
transparency, the user may switch it Off to pass the ATC-LTC HANC
packet on line 10.
Output-Matrix This setting will only work if S352_Insert is set to On. It enables you to set
the colorspace in REC709 (default) or REC2020. When set to either REC709
or REC2020, the S352 data is included in the s352 packet. (This does not
change anything in the picture.)
HDR_Curve_Out The dynamic range is the range of information between the lightest and
darkest part of an image, also known as an image’s luminosity. This setting
enables you to set the dynamic range in standard dynamic range SDR
(default), HLG, PQ or SLOG3. With all of these settings, the S352 data is
included in the S352 packet. (This does not change anything in the
picture.)
Bit_Depth_Out Bit depth is the range of bits being used. This setting enables you to set the
bit depth to Narrow (8bits) or Full (10bits). When set to either Narrow
(default) or Full, it includes this data in the S352 packet. (This does not
change anything in the picture.)
S2016-Line With this setting you select a line in the VBI to where the AFD (SMPTE 2016)
data should be written. Lines 0 till 31 are selectable. By default it is set to
line 17.
INSTALLATION AND OPERATION MANUAL
Synapse 2GF100 - 2GF110 | 5. Settings Menu | 13