4.4.7.
Restriping Clips
Limitation of the Remote Panel Interface
The function to restripe the timecode of a clip via the Remote Panel is restricted as
follows and you should use the VGA interface to change these parameters:
•
You can modify only the primary timecode.
•
You cannot modify the date of the clip.
•
You cannot modify the type of the primary timecode.
In the Remote Panel Interface
To restripe the timecode of a clip, proceed as follows:
1. Recall the clip by pressing the corresponding
F_
key.
2. Move the jog dial to reach the picture where you want to define a new timecode.
3. Press the
MENU
key to access the secondary menu.
4. Press
SHIFT+C
to call the
Set TC
function.
5. Enter the new timecode for the current picture.
6. In 59.94 Hz modes (NTSC), press
SHIFT+MENU
to select between 'Drop Frame'
and 'Non Drop Frame' modes.
7. Press the
D
key to select 'CAM' or 'CLIP' mode.
◦
In 'CAM' mode, only the timecode of the camera angle loaded on the primary
channel will be changed.
◦
In 'CLIP' mode, the timecode of all camera angles of the clip will be changed.
8. Press
ENTER
to confirm or
MENU
to cancel.
The primary timecode of the entire clip is updated according to the new timecode value so
that the timecode remains continuous over the whole clip.
Next time this function is called, the value previously used will be set as default.
OPERATION MANUAL Multicam LSM 12.05
4. Clip Management
67
Содержание Multicam LSM
