Evoqua WALLACE & TIERNAN MFC, Инструкция по эксплуатации

Страница: 182 / 268

182
WT.050.580.000.DE.IM.0714
Installation
MFC
6.
6.3.2 Filling the cell sand (DEPOLOX
®
5 only)
Caution!
Before opening the cover on the pressurised version always first
release the pressure in the cell body with the drain screw.
1 Close the ball valve on the sample water inlet and outlet
(pressurised version).
2 On the non-pressurised version, remove the protection plugs
on the cell body cover of the 3 electrode cells.
On the pressurised version, unscrew the protection plugs on
the cell body cover of the 3 electrode cells.
3 Fill half a cap from the plastic bottle with cell sand and pour it
into the cell body (approx. 1/2 cm³ cell sand).
4 On the non-pressurised version, replace the protection plugs
on the cell body cover of the 3 electrode cells.
On the pressurised version, screw the protection plugs on the
cell body cover of the 3 electrode cells.
Please note
Make sure that the opening (especially the threads in the
pressurised version) is clean; rinse off with distilled water, if
necessary.
5 Reopen the ball valve on the sample water inlet and outlet
(pressurised version).
Please note
The system must be recalibrated approx. 4 hours after each time
the cell sand is replaced.
The calibration must be checked after one day.
14 Set to the "AUTO" operating
mode Display 3
Page 149
15 Repeat calibration after 24 hours
running time Display 3
Page 149
Seq. Task
Chapter and
page reference
Comp.