Evoqua WALLACE & TIERNAN Barrier M 1200, Руководство по эксплуатации

Страница: 28 / 110

28
WT.090.370.000.DE.IM.0715
Description
Barrier M
3.
3.5.4 Menu structure
The Barrier M has three different menus:
• Operator menu
• Service menu, Level 1
• Service menu, Level 2
The menus are shown on the display. The menus are accessed
with the UP key and the acknowledge key.
Operator menu During normal operation, the user can only access the operator
menu with the following functions:
• Reading off important unit values as well as error messages
und current state of the alarms and digital inputs and outputs
and values of analog inputs
• Resetting the elapsed time clock (switching cycles), for
example after replacing lamps
• Programming or adjustment of the cleaning interval (only for
automatic cleaning mechanisms)
• Manual start of a cleaning operation (only for automatic clea-
ning mechanisms)
• Performing an LED test
• Resetting the alarm messages after remedying the error
• Selecting test mode to perform a UV sensor test
• Selecting the language
Service menu The service menu is password protected and is only accessible to
trained and authorized technical personnel.
It is divided into two levels:
• Service Level 1 and
• Service Level 2
Service Level 1 In Service Level 1, the UV disinfection unit is configured at the fac-
tory in line with the specific order. The functions are specified and
limit values set. In consultation with Evoqua, these factory settings
can be changed and adapted to the conditions on site. These
changes must be recorded in the setting data configuration sheet
(page 2 of the operating manual). In addition, it is possible to view
the total number of operating hours in the Service menu; this can-
not be reset.
Service Level 2 Service Level 2 is a Factory menu that is accessible exclusively by
Evoqua Water Technologies GmbH, Günzburg factory personnel
after entering another password.