4.0
BASE DIAGRAM
5.0
TROUBLESHOOTING
SWITCHING LEAD PLUGS INTO
PUMP OUTPUT OF CHLORINATOR.
HEATER OUTPUT CABLE
PLUGS IN HERE.
FILTRATION PUMP SOCKET
Fig. 2
6.0
WARRANTY
6.1
This product is covered by a 2 year limited warranty against component failure or faulty
workmanship from the date of installation.
6.2
Faulty units should be returned to the dealer from which the unit was purchased.
6.3
Damage to the unit due to misuse, power surges, corrosion from pool chemical fumes,
lightning strikes and or installation that is not in accordance with the manufacturer’s
instruction may void the warranty.
6.4
Warranty does not include on-site labour or travel costs to or from installation site.
Fault/Problem
Possible Causes and Remedies
No power to the
display
Power point is faulty - Test power point with a known working appliance. If the
power point is operational, check the controller in another power point. If there is
still no display, send the controller for repair.
Pump will not start
The pump will only ever run for the purpose of automatic heating if the pool is below
the temperature limit set in the heater or for filtration purposes with the filtration
times set on the chlorinator. If the pump does not operate, then plug the pump into
a power point and test. If the pump is OK then the controller requires repair.
Pump will not stop
Turn off power to the controller, ensure the pump stops. If the pump continues to
operate then unplug it from the power point and connect it to the 240V AC socket
marked PUMP at the bottom of the controller.
Pool not heating
Ensure that the Heater Output cable is connected to the plug properly and that the
plug is pushed in.
Check that the heater has power connected.
Check that the Heater Output cable is connected to the appropriate position inside
the heater according to the heater manufacturer’s instructions.
Evolution Water and Lighting Solutions
1/33 Hinkler Drive, Highland Park QLD 4211, Aus61 7 5565 0000
© 2022 Evolution Water and Lighting Solutions. All rights reserved.