4
EvoHeat CS-i Commercial Inverter Series Heat Pump
3. Safety Instructions
•
Installation, repair or relocations must be done by a fully qualified person and not by the customer. If done
incorrectly it may cause fire, electric shock, water leakage and other hazards.
•
Maintenance and operation must be carried out according to the recommended time and frequencies, as
stated in this manual.
•
To avoid risk of electrical shock, the unit must have a good power connection and earthing.
•
If the supply cord is damaged, it must be replaced.
•
Use genuine standard spare parts only.
•
When an abnormality (smell of burning, etc.) occurs, stop the unit and disconnect the power or turn off the
breaker. If the unit continues to be operated in an abnormal condition, it may cause a fire or hazards.
•
Do not insert fingers or objects into the fans or evaporator of the unit.
•
The unit is equipped with an over-load protection system. After a previous stoppage, the unit will not start
for at least 3 minutes.
•
For unit cleaning or maintenance, switch off and disconnect the power of the unit.
•
Do not install the unit near flammable gas or spray flammable substances near it.
•
Ensure the heat pump is installed on a strong and stable platform.
•
A circuit breaker must be installed for the unit.
•
Use supply wires suitable for 75°C
•
The appliance must be fitted with means for disconnection from the supply mains having a contact
separation in all poles that provides full disconnection under overvoltage category III conditions, these
means must be incorporated in the fixed wiring in accordance with the wiring rules.
•
An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be
connected in fixed wiring.
•
Directive 2002/95/EC (RoHs): This product is compliant with directive 2002/95/EC (RoHs) concerning
restrictions for the use of harmful substances in electric and electronic devices
* Caution: Single wall heat exchanger, not suitable for potable water connection.
