Evinrude E25DELSES, Руководство оператора, Страница: 45 / 80

42
Using Your E-TEC Outboard
SPECIAL OPERATING CONDITIONS
SALT WATER
Anode protection for the outboard has been
provided for use in salt or brackish water.
Upon removal from salt water, leave outboard
in a vertical position until its cooling system
has drained. During long periods of mooring,
tilt the gearcase out of the water, except in
freezing temperatures. Flush the outboard, if
desired. Refer to
Short-Term Storage on
page 51.
Salt Water Lubrication Points
1. Tilt lever and swivel bracket lubrication points
(annually)
1. Tilt tube lubrication points (annually)
2. Tilt lever shaft (annually)
1. Tiller handle lubrication points (annually)
WEEDY WATER
Weeds block water intakes and may cause
your outboard to overheat. Weeds on the pro-
peller create vibration and reduce boat speed.
When operating in weedy water, run at slow
speeds and in REVERSE frequently to clear
weeds from the propeller and water intakes.
Check the water pump indicator often.
If REVERSE operation does not clear away
weeds, SHUT OFF the engine. Remove
weeds from propeller area and water intakes
before operating at higher speed.
HIGH ALTITUDE
Your outboard’s EMM will automatically com-
pensate for changes in altitude. However, if
you boat above 3000 ft. (900 m), you will ex-
perience a slight loss of power due to reduced
air density.
If your engine drops below the recommended
RPM operating range at full throttle, have your
Dealer select a lower pitch propeller.
If you return to sea level, have your Dealer in-
stall the original propeller and verify correct
RPM operating range.
1
007032
007033
1
2
1
007020