Evinrude E-TEC 115, Оригинальное руководство пользователя

Страница: 15 / 90

13

S
AFETY
I
NFORMATION ON THE
O
UTBOARD
HANG TAG – H.O. MODELS
All H.O model outboards are shipped with the
following hang tag attached.
HANG TAG –
PONTOON SERIES OUTBOARDS
All Pontoon Series outboards are shipped
with the following hang tag attached.
REMOTE CONTROL DECALS
All remote controls have the following labels
attached.
356199
A
WARNING
Pontoon Series outboards are intended
to be installed ONLY on pontoon boats.
Boat hulls other than pontoons may
experience instability and steering
torque if operated above certain speeds.
If any adverse conditions occur, reduce
throttle and/or adjust tilt angle to main-
tain control. If you experience boat insta-
bility and/or high steering torque, see
your Dealer to correct these conditions.
If the bow of the boat plows the water at
high speeds, the boat may bow steer or
spin suddenly, possibly ejecting or oth-
erwise seriously injuring occupants.
357258
Significant variation from this initial setting, either up
or down, could result in engine dammage caused by excessive
operating temperatures.
This outboard has been designed for high performance
applications. Its mounting height on the transom will have a
significant effect on top speed, acceleration, and coolant
delivery. Initial installation should place the propeller shaft
centerline approximately 3.6 in. (9 cm) below the bottom of
the boat. Small vertical adjustments should then be made to
optimize performance.
N O T I C E
I M P O R T A N T
008488
Locate, read and
understand operator's
guide and all warnings.
Failure to do so could
result in serious injury.
Operator's
Guide
WARNING
WARNING
Attach engine shut-off cord
(Lanyard) to operator.
Shift position
Reverse / Neutral / Forward