9
8
NEVER DISASSEMBLE MARKER UNTIL REMOVING ALL GAS OR AIR FROM THE
MARKER. RULES FOR SAFE HANDLING OF COMPRESSED GAS OR AIR MUST BE
FOLLOWED AT ALL TIMES.
FIRST TIME USERS FOLLOW INSTRUCTIONS CAREFULLY UNTIL FAMILIAR WITH MARKER
1. Attach threaded barrel firmly to marker.
2. Employ barrel blocking device (barrel condom, bag, sock or plug) firmly into or onto barrel.
3. Pull the cocking rod straight back from the rear of the marker until
the cocking mechanism locks back in the cocked position. Figures 1
and 2.
4. Turn marker “on.”
5. Squeeze the trigger with an even pressure. The cocking knob will
snap forward into the uncocked position.
6. Attach empty loader into feed tube. Use provided O-rings to make
the hopper snug.
7. Always cock the marker before attaching air.
8. Before attaching air source, read and understand the section in this
manual on “Compressed Gas/Air” (page 10/11). Follow safety rules
for handling compressed gas/air. If any leak occurs in the air system
or marker refer to troubleshooting guide or to a qualified airsmith. Use only cylinders for
compressed gas or air that comply with all applicable laws and regulations, including but
not limited to those of the U.S. Department of Transportation, OSHA, Compressed Gas
Association, and/or American Society for Testing and Materials.
Figure 1. Pull Back
Figure 2. Fully Cocked
EVERY PERSON WITHIN RANGE OF AN AREA WHERE ANY PAINTBALL MARKER IS IN
USE MUST WEAR PROTECTIVE GOGGLES AND HEADGEAR SPECIFICALLY DESIGNED
FOR PAINTBALL.
WARNING
WARNING
9. Test for function after attaching air source by squeezing the trigger. The marker should
shoot air and the cocking knob should cycle forward and back, stopping in the cocked
position, after each trigger squeeze. Repeat several times. If the marker does not recock
itself, see page 29. Your Omen is NOT broken. It just needs the recock increased slightly.
10.Turn marker “off” and install barrel blocking device. Paintballs may then be loaded.
o p e rating the evil omen
™
m a r k e r
o p e rating the evil omen
™
m a r k e r
WARNING
WHEN COCKING THE PRESSURIZED MARKER, DO NOT RELEASE THE COCKING
ROD UNTIL AFTER THE COCKING MECHANISM HAS LOCKED BACK INTO THE
COCKED POSITION; RELEASING THE COCKING ROD DURING COCKING CAN
CAUSE THE MARKER TO SHOOT.
WARNING
BEFORE DISASSEMBLY, STORAGE, OR TRANSPORT OF THE MARKER, REMOVE AIR
SOURCE FIRST. THEN REMOVE ALL PAINTBALLS FROM THE MARKER, BARREL, AND
LOADER. REMOVE ALL GAS OR AIR FROM THE MARKER BY CYCLING MARKER AFTER
TANK IS REMOVED. THE REGULATOR WILL HOLD A SHOT EVEN AFTER THE TANK IS
REMOVED UNLESS THE MARKER IS FIRED. INSERT BARREL BLOCKING DEVICE AND
SLIDE THE ON/OFF SWITCH TO THE “OFF” POSITION.
On/Off
Switch
DO NOT LEAVE MARKER IN DIRECT SUNLIGHT. IN EXTREME CIRCUMSTANCES IT
CAN CAUSE THE BOLT TO SWELL.
Charge Port
Cover
Omen Manual 2.0 6/21/05 9:56 AM Page 8
