PROGRAMMING EXAMPLES
To set rate of fire to 20bps:
Start with the power turned off, hold in trigger and turn power on. Wait for about 2 seconds
and LED will come on, release trigger and then pull it once more and hold until the LED turns
off, this selects the Ball/Second register. Starting at five, click the trigger while counting and hold
the trigger in on the 20th count. Hold until the LED goes out, meaning the value has been
accepted, and then release the trigger once again. It will then reboot with the new value
indicated by a single flash and it will then be live and ready to fire.
Setting Electronic Trigger Sensitivity to 5 points
Start with the power turned off, hold in trigger and turn power on. Wait for about 2 seconds
and LED will come on, release trigger and then pull it once and release, then pull a second time
and hold until the LED turns off, this selects the de-bounce register. Starting at one, click the
trigger while counting and hold the trigger in on the 5th click. Hold until the LED goes out
meaning the value has been accepted and then release the trigger once again.
It will then reboot with the new value indicated by a single flash and it will then be live and
ready to fire.
25
24
charging
EVIL O M E N
™
2.0
DO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED
TO DO SO. DO NOT DISASSEMBLE MARKER UNTIL IT IS COMPLETELY DRAINED
OF COMPRESSED GAS OR AIR AND ALL PAINTBALLS HAVE BEEN REMOVED. ALL
FILLING OF COMPRESSED GAS OR AIR CYLINDERS MUST BE DONE BY QUALIFIED
PERSONS.
CONTACT PMI, INC., FOR REPAIR ASSISTANCE AND INFORMATION REGARDING
AUTHORIZED REPAIR FACILITIES. PHONE 800.579.1633; WWW. BUYPMI.COM
PAINTBALL MARKER AIR SYSTEMS MUST BE REPAIRED OR REPLACED ONLY WITH
THE CORRECT PRESSURE RATED COMPONENTS.
WARNING
The EVIL OMEN
™
is easy to strip for cleaning and basic maintenance.
Regular cleaning and
maintenance is highly recommended, including frequent checks of all air system
components.
Keep screws tightened. Replace worn components with factory parts; all
leaks must be repaired promptly. Air system repairs are best performed by the factory or
an authorized factory repair facility; contact PMI for information regarding authorized repair
facilities: 1.800.579.1633.
The OMEN
™
battery is a 9 volt rechargeable battery. The battery needs a full 22 hours to charge
before it is full. The battery does not come fully charged. For best long term battery life, EVIL
recommends you charge your OMEN
™
frame for a full 22 hours before using it. You can use
regular 9 volt batteries with this frame if your rechargeable battery is dead or you want to play
with the frame right away. A blinking on/off indicator light means your OMEN
™
frame needs to
be charged right away.
Charge Port
TURN MARKER OFF TO CHARGE
Maintaining EVIL OMEN
™
2.0
The trigger frame handle
might get warm during
charging.
Loss of rear gripframe
screw (59) can cause sear
not to drop and imitate a
dead battery.
O M E N
™
2.0 BOARD PROGRA M M I N G
WHEN SETTING BALLS/SECOND ALWAYS START COUNTING AT FIVE BECAUSE FIVE IS THE
LOWEST SETTING. WHEN SETTING THE ELECTRONIC TRIGGER SENSITIVITY ALWAYS START
COUNTING AT ONE. ALL PROGRAMMING IS DONE USING THE LED ON THE RIGHT SIDE OF
THE EVIL OMEN TRIGGER FRAME.
NOTE: If at any point a mistake is made just turn power off and start again. The
selected values are stored in permanent memory and will remain set even without
a battery connected.
Omen Manual 2.0 6/21/05 9:56 AM Page 24
