Evidence Cross-8/HPoE-10G, Руководство пользователя

Страница: 199 / 321

To type the password. The field can be input 31 characters, and the allowed content is the
ASCII characters from 32 to 126.

Password (again) :
To type the password again. You must type the same password again in the field.

Privilege Level :
The privilege level of the user. The allowed range is 0 to 15. If the privilege level value is 15,
it can access all groups, i.e. that is granted the fully control of the device. But others value
need to refer to each group privilege level. User's privilege should be same or greater than
the group privilege level to have the access of that group. By default setting, most groups
privilege level 5 has the read-only access and privilege level 10 has the read-write access.
And the system maintenance (software upload, factory defaults and etc.) need user
privilege level 15. Generally, the privilege level 15 can be used for an administrator account,
privilege level 10 for a standard user account and privilege level 5 for a guest account.
Buttons

Apply :
Click to save changes.

Reset :
Click to undo any changes made locally and revert to previously saved values.

Cancel :
Click to undo any changes made locally and return to the Users.

Delete User :
Delete the current user. This button is not available for new configurations (Add new user)
11-1.2 Privilege Levels
This page provides an overview of the privilege levels. The switch provides user set Account,
Aggregation, Diagnostics, EEE, GARP, GVRP,IP, IPMC Snooping LACP LLDP LLDP MED MAC
Table MRP MVR MVRP Maintenance Mirroring POE Ports Private VLANs QoS SMTP SNMP
Security Spanning Tree System Trap Event VCL VLANs Voice VLAN Privilege Levels from 1 to
15 .
Web Interface
To configure Privilege Level in the web interface:
1.
Click Security, Management and Privilege Levels.
2. Specify the Privilege parameter.
3. Click Apply.
Figure11-1.2: The Privilege Level configuration
Parameter description: