evertz IXG CloudBridge, Руководство пользователя

Страница: 19 / 52

IXG CloudBridge
Internet Exchange Gateway Server
Revision 1.0
Page - 11
4.3. SETUP COMMUNICATION BETWEEN TX SIDE AND RX SIDE
The IXG CloudBridge Server is a powerful module which gives users the capability to transport video
streams over lossy networks such as internet.
This section outlines the basic procedure to configure a transmitting and receiving IXG CloudBridge
Server to pass video over a network. Each IXG module has the ability to do multiple transmit and receive
videos based on what type of license is installed. Setup of each transmit and receive port is identical to
that outlined in this setup guide.
To start passing data between the ports, IP address configuration is required. Follow these steps to set up
communication between Side 1 (TX) and Side 2 (RX).
4.3.1. Side 1 (TX)
1) Go to the webpage and click on the IP input tab to check port link status (port link status shows the
connection between the video source and access port of the card). “Up” status means it is
connected the network that is hosting the source video. Please verify the connection from the IXG
CloudBridge Server to the source network if the port status is “down.”
2) Check the link speed and data rate. This will confirm the communication between the card and the
source.