evertz HD9690 Series, Инструкция по эксплуатации, Страница: 80 / 130

HD9690 Series HDTV Graticule Generator Manual
Page 4-12
Revision 1.5
DESKTOP CONTROL PANEL OPERATION
4.3.4. Controlling the Object Colour
Press the COLOUR button to control the colour level of the selected object (the one with its button
blinking). The colour can be adjusted in the range of “0” through “14”, in single digit increments, using
either shaft encoder. The colours that will be displayed for each value are shown in Table 4-2. The
colour
adjust function will be deselected after 3 minutes of panel activity, or when another button is pressed.
4.3.5. Remote Panel Display when Controlling the Objects
When an object is selected the name of the selected object will appear on the display. After a 3-second
timeout, the display will show the current value of the object parameters being controlled by the knobs (as
determined by the
CTRL SEL menu).
When the object is turned off by pressing its button again while it is blinking, the display will show that the
object is turned off. If the object is subsequently turned on, the display will indicate that it is on, and then
will show the object parameters after a 3-second timeout.
When object attributes are being modified by turning one of the shaft encoders, the attribute being
controlled is displayed along with its current value.
4.3.6. On Screen Display when Controlling the Objects
When an object is selected the name and attributes of the selected object will appear on an on screen
display (OSD). (Unless the
OSD TIMER menu item on the Setup menus is set to Off ). The OSD can be
located in one of 5 positions on the screen and shows the following attributes for the object:
Object name (off | on)
Ctrl Active Control name
Centred Object centering
User aspect Aspect ratio
Aperture Aperture applicable to object
Width Width in pixels (% of aperture width)
Height Height in lines (% of aperture height)
Top Object Top (raster line) Btm Object Bottom (line)
Left Object left (pixel number) Right Object right(pixel)
Centre pos Object centre position (line, pixel)
When the object is turned off by pressing the
ON/OFF key, the OSD will show that the object is turned off.
When object attributes are being modified by turning one of the shaft encoders, the attribute being
controlled is shown as the
active control name .