evertz 8010TM, Инструкция по эксплуатации

Страница: 65 / 98

Model 8010TM SDI Time Code Master Manual
OPERATION
Revision 1.5.1
Page 3-35
Press the SELECT key to ‘arm’ the event register for a single event. Press the SELECT key again to
‘disarm’ the event register. A lower case ‘
s
’ will be shown to the left of the hours digits of the display
when the register is armed for a single event. When the event register is armed for single event mode,
the output will occur the
first time the comparison matches. The event must be re-armed for the event
to occur again.
Press the
SELECT keys to ‘arm’ the respective event register for continuous events. Press the
SELECT keys again to ‘disarm’ the event register. A lower case ‘
c
’ will be shown to the left of the hours
digits of the display when the register is armed for continuous events. When the event register is armed
for continuous event mode, the output will occur
each time the comparison matches.
When the time code being generated matches the value entered into the GEVT register and the GEVT
register is armed, the event output will be activated for the duration set in the
GPO DURATION menu.
When the time code being read by the Reader matches the value entered into the REVT register and
the REVT register is armed, the event output will be activated for the duration set in the
GPO
DURATION menu.
3.7.10. Configuring the Serial Port
3.7.10.1. Selecting the Serial Port Baud Rate
SERIAL BAUD RATE The SERIAL BAUD RATE menu item is used to set the baud rate of the
remote control serial port. The 8010TM supports four different baud
rates from 2400 to 38400 baud. Select the highest baud rate that your
computer can use for best results.
Baud rate 2400
Baud rate 9600
Baud rate 19200
Baud rate 38400
3.7.10.2. Testing the Serial Port
SERIAL TEST The SERIAL TEST menu item is used to turn on a serial port test
message. When the serial test is on, the 8010TM outputs a message
similar to:
EVERTZ DTCG 8010TM SOFTWARE VERSION DG86D1.M
R020822
Serial test off
Serial test on
3.7.11. Testing the RAM
XRAM TEST The XRAM TEST menu item is used to initiate a test of the Character
RAM.
Xram test on?
3.7.12. Adjusting the Front Panel Display Brightness
DISPLAY LEVEL The DISPLAY LEVEL menu item is used to adjust brightness of the
front panel display. Use the

and

keys to adjust.
Display level xx