evertz 8010TM, Инструкция по эксплуатации

Страница: 58 / 98

Model 8010TM SDI Time Code Master Manual
Page 3-28
Revision 1.5.1
OPERATION
3.7.1. Selecting the Video Type
VIDEO TYPE The VIDEO TYPE menu item is used to program the 8010TM for the
digital video format.
When you select
auto the 8010TM will auto detect the line rate and
automatically reconfigure itself. The current video standard will be
shown in brackets.
Select
525 for operation with 525 line video conforming to SMPTE
125M.
Select
625 for operation with 625 line video conforming to EBU Tech
3267-E (1992) or the 4:2:2 level of IUT-R 601.
Video auto (525)
Video 525
Video 625
3.7.2. Adjusting the Output Level of the LTC Generator
LTC OUT LEVEL The LTC OUT LEVEL menu item is used to adjust amplitude of the LTC
output. Use the

and

keys to adjust. The recommended output
level setting is 35, which is approximately 1 volt peak to peak.
Ltc level xx
3.7.3. Setting the VITC Deleter Line Range
VITC DEL START The VITC DEL START and VITC DEL END menu items are used to
select the lines that will be erased by the VITC deleter. This function
allows existing VITC on the incoming program video to be removed
prior to inserting new VITC on the output. VITC deletion is enabled
between the lower and higher line numbers shown (inclusive).
When the
VITC DEL START menu item is first selected, the starting
line number for the VITC deleter will be shown. Press the left and right
(

,

) keys to change the starting line. When either the start or end
line number is set to –- the VITC delete function is disabled. Press the
down (

) key to select the VITC DEL END menu item. Press the left
and right (

,

) keys to change ending line.
Delete Start = xx