evertz 5010, Инструкция по эксплуатации

Страница: 63 / 108

Model 5010 Time Code Master Manual
OPERATING INSTRUCTIONS
Revision 3.1.1
Page 4-29
4.6.2. Selecting the Format of the Time and User Bit Data
The
MODE
menu item is used to select the type of information that is contained in the time and user
bits of the reader.
Select
TIME DATA
when the time contains normal time information and the user bits contain numeric
data.
Select
TIME TIME
when both the time and the user bits contain time information.
Select
DATA DATA
when both the time and the user bits contain numeric data.
Select
TIME DATE
when both the time contains normal time information and the user bits contain date
information (recorded in the TIME DATE format of the generator).
4.6.3. Setting the VITC Reader Line Range
(model 5010-VITC only)
The
RDR VITC LINES
menu item is used to select the lines that are enabled for VITC reading. VITC
reading is enabled between the lower and higher line numbers shown (inclusive). If the reader is not
assigned as a VITC reader then this menu item is not available.
When the
VITC LINE
sub-menu is first selected, the START line number will be in reverse video
indicating it can be changed. Press the up and down ( Ï , Ð ) keys to change the starting line. Press
the right ( Î ) key to highlight the END line, indicating that it can be changed. Press the up and down (
Ï
,
Ð
) keys to change the ending line.
4.6.4. Selecting the VITC CRC
(models 5010-VITC and 5010-VITC-24 only)
The
RDR VITC CRC
menu item is used to select whether the VITC data being read has a normal CRC
or the special CRCs used by the
Evertz
Film Footage Encoders.
Select
NORMAL
to read VITC data with standard SMPTE/EBU CRC encoding.
MODE
TIME USER
TIME DATA
TIME TIME
DATA DATA
TIME DATE
RDR VITC LINE
LINE RANGE:
START
END
10 20
RDR VITC CRC
NORMAL
SPECIAL