evertz 500DA-AESB, Руководство пользователя

Страница: 4 / 10

Frame Manual
500DA-AESB Balanced AES Audio Distribution Amplifier
500DA-AESB - 2
Revision 1.2
2. INSTALLATION
The 500DA-AESB is shipped with a 500BAL-IO terminal block adapter that must be installed to the rear
panel of the frame. For information on inserting the module into the frame see section 3 of the 500FR
chapter.
Figure 2-1: 500BAL-IO Rear Panel Adapter for 500DA-AESB
Refer to the pictures in Figure 2-2 for additional information on installing the panel adapter.
1. Using a Philips screwdriver, remove the screws above and below the slot where you want to install the
panel adapter. (Figure 2-2a)
2. Install the two jack posts that were supplied with the panel adapter. Tighten with pliers or a hex
wrench. (Figure 2-2b)
3. Slide the BNC connectors of the panel adapter over the BNC connectors on the rear of the frame. The
panel adapter should go all the way in until it touched the jack posts.
4. Reinstall the screws and tighten with a Philips screwdriver. (See Figure 2-2c).