2408LT Standalone L-Band Fiber Optic Transmitter
Revision
1.5
Page -
3
2.1. 2408LT
CONNECTIONS
"
Coaxial connectors accept conductors in the range of 21-19 AWG (0.41-0.64 mm
2
).
Using a larger conductor will damage the connector. If you are using cable with a
center conductor larger than 19 AWG (0.64 mm2), a connector with a fixed or crimp
pin of a suitable diameter must be used (e.g. Amphenol Connex 222123 (for RG6) or
Canare FP-C series).
RF IN:
Input F-Type connector for L-band satellite signals. This connector can also provide
LNB power and 22 kHz tone back to the satellite dish.
If LNB POWER LED is on or flashing, there will be DC voltage for LNB power at
the RF INPUT connector. This can damage some test equipment.
The user can turn off the LNB power by switching LNB MODE switch to the OFF
position.
MONITOR OUT:
Output F-Type connector provides a buffered copy of the incoming RF signal for
monitoring purposes (signal peaking, etc.) or coaxial distribution.
"
While unused, it is recommended that this connector be terminated with a 75 Ohm load.
DC IN:
Input F-Type connector for DC power supply. Input power supply range is from 9-23
VDC.
Do not exceed 22VDC at the DC input connector or damage to the unit will result.
FIBER OUTPUT:
FC/APC female connector with the optical output from the 2408LT. This connector
should be connected to the FIBER IN connector of an appropriate Evertz companion
receiver model at the destination end with a suitable fiber optic cable. The 2408LT
transmits on the 1310 wavelength unless otherwise indicated by the wavelength label.
2.2.
CARE AND HANDLING OF OPTICAL FIBER
2.2.1. Safety
!
CLASS 1 LASER PRODUCT
Background colour: yellow
Triangular band: black
Symbol: black
