PARTS LIST
INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE! IF YOU
DO NOT UNDERSTAND THE INSTRUCTIONS, OR DO NOT FEEL THAT YOU CAN FOLLOW THEM
SAFELY, CONTACT A QUALIFIED CONTRACTOR.THE WARRANTY WILL BE HONOURED IF
ACCOMPANIED BY AN ORIGINAL SALES RECEIPT, AND ONLY IF THE INSTRUCTIONS HAVE BEEN
FOLLOWED EXACTLY. Before beginning, please check to ensure you have all the parts listed below. To
acquire missing parts please visit www.everik.com/parts.html or call 1-866-604-6966.
• The EverMount EM-P1 is designed to mount a Plasma or LCD monitor onto a vertical wall. Hardware for
mounting to a wood stud is included. For mounting to any other surface, contact a qualified contractor.
• This product will hold flat screens 32 to 62 inches and weighing up to 165 lbs.
• You will need a Phillips screwdriver, and a drill with a 3/16" bit.
• A second person will be required to assist with step 3 and 4.
• If you do not understand the instructions, or are not sure you can follow them safely, contact a qualified
contractor.
092008
Bag Ref
Item
Qty
Bag Ref
Item
Qty
1
A
M4 Lock Washer
4
5
N
Large Spacer
4
B
M4x12 bolt
4
O
Small Spacer
4
C
M4x32 bolt
4
P
Large Washer
4
D
Cotter Pin
1
Q
Small Washer
4
2
E
M5 Lock Washer
4
6
R
Concrete Anchor
6
F
M5x12 bolt
4
S
Lag Bolt
6
G
M5x32 bolt
4
T
Large Washer
6
3
H
M6 Lock Washer
4
7
U
Small Hex Bolt
8
I
M6x12 bolt
4
V
Nut
8
J
M6x32 bolt
4
W
Washer
16
4
K
M8 Lock Washer
4
L
M8x16 bolt
4
M
M8x40 bolt
4
Tilt Plate
Monitor Bracket
Step One
If a 5 degree tilt is desired, install tilt plates, otherwise
continue to step 2.
To install tilt plates on monitor brackets:
i) Attach a tilt plate to each side of the monitor bracket
using tilt plate screws (U), washers (W) and nylon
nuts (V) as shown.
ii) Repeat this process for the other monitor bracket.
iii) The tilt plate’s “hooks” are placed over the top track
of the wall plate in step 4.
U
V
W
1
Figure 1
EM-P1
