EVERLAST CLIMBING INDUSTRIES, INC.
INSTALLATION INSTRUCTIONS: CORDLESS MAT-LOCKING
®
SYSTEM
!
WARNING
THE PROPER CARE AND ONGOING MAINTENANCE OF YOUR CLIMBING WALL IS
ESSENTIAL AND IS YOUR RESPONSIBILITY. PLEASE REFER TO THE
SAFETY, CARE AND MAINTENANCE INSTRUCTIONS.
MANUFACTURED BY: EVERLAST CLIMBING INDUSTRIES, INC 800.476.7366
4/18/2016
Materials
Included:
Tools:
Mats
Drill
Mat-Locking Holds
#2 Phillips Head Bit
(including slider, bolt and washer)
Security Wrench
1-5/8” Screws
Bolts
INSTALLATION INSTRUCTIONS:
(Please read all instructions thoroughly before starting to install)
1. Lay mats on the floor so that the bottom straps are closest to the climbing wall and line
up with the T-nuts on the wall. Attach the bottom straps to the climbing wall using the
bolts and security wrench provided. Choose the grommet hole that allows the strap to
have some slack - you may need to angle the straps to reach a nearby T-nut. (Not pictured.)
2. With the bottom straps attached to the climbing wall, stand the mats up against the
climbing wall.
IMPORTANT NOTE: The Cordless Mat-Locking System is designed for the mats to rest on the
floor. Hanging the mats off of the floor will shorten their life and make them much harder
to use.
3. Hook the loop of the nylon webbing over a Mat-Locking Hold and hold it in a correct
position on the climbing wall. Make sure the loops are not pulled too tight as this will make
the locking/unlocking process more difficult. Where two mats come together, pass one
loop through the other before hooking it over the Mat-Locking Hold.
4. Using a drill with a #2 Phillips Head Bit, screw the three 1-5/8” screws through the Mat-
Locking Hold and into the climbing wall, starting with the center mounting hole first.
5. Repeat steps #3-4 to install the remainder of the Mat-Locking Holds on the wall.
6. Starting with the first Mat-Locking Hold, rotate the slider into the “locked”
position. Tighten with the security wrench.
7. Repeat step #6 for the remainder of the Mat-Locking Holds.