Value IP Series Network Cameras – H265, 2MP / 5MP / 8MP
66
5.8.2.6
Cross-Counting Detection
Only 5MP and 8MP models support this function. The camera will count the times when objects (people,
vehicle or other objects) cross a pre-defined line, and the Cross-Counting Detection event will be triggered. You
can configure some event actions like event recording, alarm output or Email alert when an event is triggered.
To search and view the statistical result of cross-counting, go to Intelligent > Analysis (please refer to
5.8.3
Analysis
).
Pedestrian Detection
Face Detection
Object Detection
Perimeter Intrusion
Line-Crossing
Cross Counting
Analysis
Cross-Counting
Switch:
Switch the button to the right to enable the function.
Timeout Duration:
After enabling the Alarm Out, select a timeout duration for the alarm output.
Post Recording:
Select a post recording time when a Cross-Counting Detection event is triggered.
Sensitivity:
Select a sensitivity for the Cross-Counting Detection. The larger the value, the higher the sensitivity.
Scene:
Select
Indoor
or
Outdoor
based on the location where your IP camera is installed.
Alarm Out:
Switch the button to the right to enable the alarm output, and then further configure the
Timeout
Duration
above.
Send Email:
Switch the button to the right to enable the Email alert function. When a Cross-Counting Detection
event is triggered, the camera will send an email alert with a snapshot image to the pre-configured Email
receiver. Note that for this function to work, you have to set up the Email function in advance (refer to
5
.
5.3
).
Rule Number:
Select a number to configure the areas.
Rule Switch:
Switch the button to the right to enable the Rule Type setup below.
Rule Type:
Select a rule type.
Enable Recording:
Switch the button to the right to enable the Cross-Counting Detection recording function.
Note that for Cross-Counting Detection recording function to work, the Record Schedule function has to be
configured (please refer to
5.8.1 Record Schedule
).
Click
Refresh
to refresh the page; click
Apply
to save the settings.
