Value IP Series Network Cameras – H265, 2MP / 5MP / 8MP
64
5.8.2.5
Face Detection
Only 5MP and 8MP models support this function. When IP Camera detects faces in a pre-defined area, the Face
Detection event will be triggered. You can configure some event actions like event recording, alarm output or
Email alert when an event is triggered.
Cross Counting
Perimeter Intrusion
Line-Crossing
Object Detection
Pedestrian Detection
Face Detection
Analysis
Level
Middle
Normal
Face Detection
Snapshot Mode
Apply Mode
Advance
Roll Range
Pitch Range
Yaw Range
Picture Quality
Min Pixel
Real Time Mode
Recognition Mode
30
30
45
100
64
Rect
Rule Kind
(0-180)
(0-180)
(0-180)
(0-100)
(32-1080)
Switch:
Switch the button to the right to enable the function.
Timeout Duration:
After enabling the Alarm Out, select a timeout duration for the alarm output.
Post Recording:
Select a post recording time when a Face Detection event is triggered.
Alarm Out:
Switch the button to the right to enable the alarm output, and then further configure the
Timeout
Duration
above.
Send Email:
Switch the button to the right to enable the Email alert function. When a Face Detection event is
triggered, the camera will send an email alert with a snapshot image to the pre-configured Email receiver. Note
that for this function to work, you have to set up the Email function in advance (refer to
5
.
5.3 Email
).
Snapshot Mode:
Select a snapshot mode.
Apply Mode:
Select a apply mode.
Advance:
Switch the button to the right to enable the advanced functions including Roll Range, Pitch Range,
Yaw Range, Picture Quality and Min Pixel.
Rule Number:
Select a number to configure the areas.
Rule Switch:
Switch the button to the right to enable the Rule Type setup below.
Rule Kind:
Select a rule kind. Options include Area and Line.
Rule Type:
Select a rule type.
