IP ADDRESS SETTING
1. Press “menu” button for 3 seconds, enter IP setting menu.
2. Using “up” “down” navigation key to select parameter needed to set. IP, Mask etc.
3. Short press “Home” key to setting mode, current setting parameter starts blinking
4. Short press number key to set needed parameter. After finishing setting, press “Home” key again.
5. To exit, press “menu” key. Note: Only press the “Home” key after finishing setting to save current
parameter.
UVC CONTROL
1. Only run the client software after the USB3.0 camera has completed self-configuration (the LED will
light up in blue, no flashing)
2. Make sure the USB3.0 camera is recognized by the PC Device Manager.
3. Make sure the interval of video format switching is more than 3 seconds.
4. Make sure the interval of control command sending from the server (via USB) to the camera, is more
than 250ms.
5. Support standard UVC interface.
PU_BRIGHTNESS_CONTROL
81 01 04 4d 00 00 0p 0q FF
PU_CONTRAST_CONTROL
81 01 04 A2 00 00 0p 0q FF
PU_SATURATION_CONTROL
81 01 04 A1 00 00 0p 0q FF
PU_SHARPNESS_CONTROL
8x 01 04 42 00 00 0p 0q FF
PU_GAMMA_CONTROL
8x 01 04 5B 0p FF
PU_WHITE_BALANCE_TEMPERATURE_CONTROL
8x 01 04 35 0X FF
PU_BACKLIGHT_COMPENSATION_CONTROL
81 01 04 33 02/03 FF
PU_POWER_LINE_FREQUENCY_CONTROL
8x 01 04 AA 00/01/02 FF
CT_ZOOM_ABSOLUTE_CONTROL
8x 01 04 47 0p 0q 0r 0s FF
CT_PANTILT_ABSOLUTE_CONTROL
8x 01 06 02 VV WW 0Y 0Y 0Y 0Y 0Z 0Z 0Z 0Z F
CT_PANTILT_RELATIVE_CONTROL
8x 01 06 01 pp qq rr ss FF
CT_ZOOM_RELATIVE_CONTROL
8x 01 04 07 pp FF
26
WWW.EVERETIMAGING.COM
