6 For Professional Technical Support call 1-844-241-5521
Installation (continued)
5
Attaching the pump to a sturdy
base
Attach the pump (A) to a sturdy base (table, board, etc.) to prevent
it from tipping over. Make sure the hoses are as straight as
possible.
WARNING
:
This pump CANNOT be submersed in
water, and the motor CANNOT get wet at all. Getting the
motor wet could cause electrocution, which could lead to
serious injury or death!
NOTE:
Do not coil or kink the hose.
Operation
Connect the motor lead wires as indicated. The pump will start immediately when connected to power.
Power Supply: The pump is designed for use with a 12 Volt DC battery. Operation requires a minimum 12 Volt power supply.
All wiring must be 12 gauge stranded copper wire that is:
A. Water resistant
B. Oil resistant
C. Flame resistant
Connect the
To
1. Red handled battery clamp
Positive (+) battery terminal
2. Black handled battery clamp Negative (-) battery terminal
NOTE:
When the water level has been reduced to approximately 1/8 in., you MUST CUT OFF THE POWER. DO NOT RUN DRY.
NOTE:
This pump can be very loud when started. THIS IS NORMAL. Once water begins to pump, the noise will dissipate.
NOTE:
If water is not pumped in 30 seconds, unplug the power cord and check the connection on the two ends of the inlet
hose to make sure there are no air leaks. Then, add water into the inlet again and repeat the process.