Eventide H90 Harmonizer, Руководство пользователя

Страница: 139 / 176

Envelope Filter Shift: Octaver allows your playing to vary the center frequency of the fi lters. This
control adjusts the degree to which the input signal’s envelop shifts the fi lter’s center frequency.
Envelope Sensitivity: Controls the sensitivity of the frequency sweeps to the input signal level.
Distortion: Controls the amount of distortion (fuzz).
Octave-Fuzz Mix: Controls the mix of octaves and fuzz.
PitchFlex
PitchFlex is designed to be used ‘live’ with either an Expression Pedal, the on board HotKnob, or the FLEX
switch. Using the Heel and Toe controls you can set the pitch shift of two voices at each end of travel of
the Expression Pedal. Turning these controls ‘OFF’ results in no pitch change. The other controls allow
you to tailor the ‘sweep’ by controlling its speed and shape.
Mix: Wet/dry mixer, 100% is all wet signal.
Pitch A/Pitch B Mix: Controls the ratio of the level of Pitch A to Pitch B.
Set Pitch A with Exp Pedal in Heel Position: Sets pitch shift of voice A in the heel position. When
‘OFF’ is selected, the voice is muted at the heel position and the pitch is set to unison.
Set Pitch B with Exp Pedal in Heel Position: Sets pitch shift of voice B in the heel position. When
‘OFF’ is selected, the voice is muted at the heel position and the pitch is set to unison.
Heel-to-toe glissando: These parameters are for use when using an Auxiliary Switch to control the
pitch change effect for voices A and B. Sets the time to move from ‘heel’ to ‘toe’. With Tempo Sync
ON the maximum is ½ note.
Toe-to-heel glissando: Parameters for use when using an Auxiliary Switch to control the pitch
change effect for voices A and B. The Delay A knob sets the time to move from the virtual ‘toe’ to
the virtual ‘heel’. The Delay B knob sets the time to move from ‘heel’ to ‘toe’. In Tempo Sync ON the
maximum is ½ note.
Low Pass Filter: A low pass
fi lter to ‘darken’ the effect.
Glissando Shape: Controls the ‘shape’ that the pitch modulation follows when using the Flex Switch.
If set to Negative values, the pitch goes slowly towards ‘Toe’ and quickly transitions to ‘Heel’,
Positive is the other way around, and 0 means the pitch shifts up and down linearly.
Set Pitch A with Exp Pedal in Toe Position: Sets voice A’s pitch shift in the toe position. When ‘OFF’
is selected, the A pitch shifter is disabled at the toe position and toe is treated as unison.
Set Pitch B with Exp Pedal in Toe Position: Sets voice B’s pitch shift in the toe position. When “OFF”
is selected, the B pitch shifter is disabled at the toe position and toe is treated as unison.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
10. ALGORITHM GUIDE
139