Eusso 2 & 4 Port VoIP Gateway, Руководство пользователя, Страница: 74 / 112

ITG User’s Guide
8.9 Configuration Management Commands
The configuration management commands allow the user to set values for system
configuration parameters. In addition, it provides mechanisms to allow a user to control
when new parameter values are put in use.
The CLI maintains three areas where the parameters are stored:
Temporary
Active
Non-volatile Storage (NVS)
When a set command is entered and processed, it changes the parameter value in the
Temporary area. This does not affect current operation of the ITG, which is using the values
in the Active area. The
config activate command moves configuration data from the
Temporary area to the Active area, where it can actually be used. Thus a user can make
multiple changes in the Temporary area using
set commands, then put them into use with a
single config activate command. (Note that the config activate command may only be used
between calls, and will usually tear down any in-progress calls when invoked.)
Configuration data in the Active area is only available while the ITG remains in operation.
If the ITG is reset, the Active area is reloaded from the data stored in NVS. Data in the
Active area may be saved to NVS by entering the
config store command.
For most of the H.323 parameter, settings won’t take effect until the ITG reset. To ensure the
H.323 setting to take effect, it is recommended to reset the ITG after changing the settings
using the
set command.
In summary:
Use set commands to make configuration parameters changes in the Temporary area
Use the config activate command to move the new values into the Active area, available
for use
Use the config store command to save the new Active values in NVS
Reset the ITG after changing H.323 settings and storing the setting to NVS.
config {activate|store|erase}
Use the activate command to manage the configuration data. A sequence of set command is
typically preceded by and/or followed by the config command for the set command to
become active.
Syntax description
activate Move the configuration from temporary area to active area.
store
Store the active configuration data into non-volatile storage.
erase Erase the configuration from non-volatile storage.
Command Line Interface
62