RADIO CONTROL SOLAR ALARM POWER CLOCK
Cat. No.
39 627
Instruction Manual
Technique Parameter:
1. Battery: 1XAA 700MAH rechargeable batteries
2. Energy Consumption:
ALARM CURRENT <12MA,
RECEIVING CURRENT <105UA,
CURRENT CONSUMPTION NORMAL
〈
25UA,
LIGHT<100MA
Using time: around 20 months when power is full if energy consumption <1.09MAH
Using Instructions:
1. Put battery into compartment, the clock will receive signal when the hour and
minute hands move to 4:00/8:00/12:00 automatically.
2. If after ten minutes no signal is received then the radio control signal is not strong
enough or unavailable and the clock will need to be set manually.
How to Set Time Manually:
2-
1. Press “M.set” longer than 3 seconds to start the time setting function time starts
and keep it pressed until the hour and minute hands movie to the desired time.
2-2. To ensure that the clock is set to the exact time desired, please keep the
“keypress” status for some time until the hour and minute hands move close to
your desired time bu
t not exact time then stop and then begin to press “M. Set”
button immediately and then stop and then begin to press again and then
stop….; repeat until the hour and minute hands move to the exact time desired.
Combined with process 2-1 will make the time setting quicker.
2-3.
Exit the manual setting status: Press “M.set” long for 8 seconds.
3. Clock is working when receiving signal
How to Set to Receive the Signal:
4-1. When a signal can be received it is updated 8 times everyday. The receiving
times are AM2:00; AM3:00; AM4:00; AM5:00; PM2:00; PM3:00; PM4:00;
PM5:00.
4-2. REC button: press it long for 3 second to set the function of receiving signal
manually.
How to Set Alarm:
5-1
. “ON” and “OFF” buttons: are only related to alarm setting. To set alarm function, it
must be on “ON” status.
5-2 .Set alarm: Set to desired time in counter-clockwise direction
