100/180 MM GRAPHICS RECORDER: USER GUIDE
User Guide
Page 15
HA261742
Issue 16 Nov 04
2.2.2 Supply voltage wiring
WARNING
DC supply voltages must never be applied to recorders fitted with isolated transmitter power supplies.
Note: The minimum recommended wire size is 16/0.2 (0.5mm
2
).
LINE SUPPLY
The supply voltage to the recorder is terminated using an IEC socket which is connected to the mating plug at the rear
of the recorder. The recorder is suitable for use with all ac voltages between 85 and 265 V RMS (47 to 63 Hz), and
requires 60 VA max. power. For recorders without transmitter power supplies, supply voltages between 110V dc and
370V dc are also suitable.
LOW VOLTAGE SUPPLY OPTION
Not suitable for recorders fitted with the isolated transmitter power supply
option.
The low voltage supply option is terminated at a three-pin connector (plug
mounted on recorder - socket on supply cable) as shown in figure 2.2.2. The
option allows the use of ac or dc supplies with the following characteristics:
AC:
20 to 42V RMS (45 to 400 Hz)
DC:
20 to 54V (See warning above)
Power: 60VA max.
2.3 DISK/PC CARD INSERTION AND REMOVAL
The disk/PC card slot is located below the recorder screen, and is protected by a flap. For 100 mm units, the bottom
of the central part of the flap is lifted and then used as a handle to pull the main flap open. For 180mm units, the pull
handle is used to gain access to the disk or pc card. Figures 2.3, below, gives details (not drawn to the same scale). If
a disk/pc card is already fitted, it is removed by pressing on the eject button.
Note: Before disk/pc card removal, archiving should be suspended (
) (wait for the green section of
the disk icon (
) to stop flashing), otherwise data might be lost.
Figure 2.3 Floppy disk/PC Card access
+V or ac
Earth
0V or ac
Figure 2.2.2 Low voltage supply pinout
Open flap
(100 mm unit)
Disk eject button
(100 mm unit)
PC Card eject button
(100 mm unit)
Open flap
(180 mm unit)
Disk eject button
(180 mm unit)
PC Card eject button
(180 mm unit)
