Eurotherm 5100e, Руководство пользователя

Страница: 78 / 136

100 MM GRAPHICS RECORDER: USER GUIDE
HA027271
Issue 12 Mar 04
User Guide
Page 74
New User ID
New Password
Retype Password
Based On Operator
Apply Discard
Add
Add User (Section 4.4.3)
Login by User List
Centralised Security
Apply Discard
Frederick Bloggs Access when
New Password
Retype Password
Connect from remote
Login Disabled
Change Alarm Setpoints
Set Clock
Archiving Control
Save/Restore
Paste/Delete Files
Full Configuration
Full Security
Apply Discard
Edit own Password
**
**
Edit Maths Constant
Preset Counters
Adjust Inputs
Access (Section 4.4.1)
Acknowledge Alarms
Reset Maths
Preset Totalisers
Start/Reset Timers
Event Permission 1
Event Permission 2
Event Permission 3
Event Permission 4
Event Permission 5
Force Change of Password
Engineer User
Select the required access level and enter the
password if required
Logout
User
User Full Name
Apply Discard
Remove
Remove User
(Section 4.4.4)
Login (Section 3.3.1)
Archive System Save/R.. Config Security Network
Login
Access
Management
Add user
Remove User
Section 4.2.2
New Full User Name
4.4 SECURITY
Touching this key allows the operator to select 'Login' (described in section 3.3.1 ) 'Access' or 'Add/Remove User' for
configuration. Selecting 'Access' displays the current user level. Touching this area allows the user to select 'Logged
out', 'Operator', 'Engineer' or any added users. The user may also go directly to logged out mode by operating the
'Logout' key.
Figure 4.4 Security configuration menus
4.4.1 Access levels
There are essentially three levels of security associated with the recorder viz: Engineer, Operator and Logged out.
(The fourth level - Service - is available only to service engineers). When logged-in at engineer level, the user can
set access permissions for Operator and logged-out levels, and can edit Operator and Engineer level passwords. The
password for both Engineer and Operator levels is set to 10 at the factory.
Note: Setting the password to 'blank' allows subsequent access without a password having to be entered.
Users with Full Security permission can Add (and Delete) users (sections 4.4.3, 4.4.4 ) and assign them individual
passwords and access permissions. User names (IDs) appear in the 'Login' and 'Access When' picklists.