Spotlight Q2L Serie
LED Leaf Barndoor Projector
EUROSEP
Instruments
1. Important Points
1.1. The leaf barndoor projector must be installed in a compatible 2/3 circuit track adaptor, stable
and securely fastened, away from any source of heat or strong magnetic fields.
1.2. The 2/3 circuit track must be connected to a mains voltage between 200-240V / 50-60Hz. If
the leaf barndoor projector is permanently connected, it is advisable to install a switch or circuit
breaker in the vicinity.
1.3. Never operate the leaf barndoor projector when the installation instructions are not followed
(see paragraph 4).
1.4. Never disassemble the optical module nor
the 2/3 circuit track adaptor.
Before any handling or operation with the leaf barndoor projector, it is
essential to take note of the following points:
The LED Q2L series Leaf Barndoor projector has been
developed to meet the particular needs of museums and
architecture.
Ideal for replacing incandescent light sources, this range
of leaf barndoor projectors uses a 16W LED module with a
color temperature of 3000 °K (warm white) and 4000°K
(neutral white), high intensity, with typical CRI (Ra) and
red rendering (R9) indexes of 95 and 90 respectively.
The luminous flux is manually adjustable from 20 to
100%, the emitted intensity is equivalent to a light system
equipped with a 100W halogen bulb.
A filter placed at the light beam output provides a
"flood" spot whose the size can be adjusted by four leaf
barndoors.
The optical body, made of aluminum (black), allows an
efficient passive cooling without any need of a forced
cooling.
The light emitted from the LED module covers the
spectrum from 400 to 700 nm with no emission in the
ultraviolet nor in the infrared.
Power is supplied directly from the mains 230V/50Hz via a 2/3-circuit track adaptor.
The projector has a vertical adjustment range of 110° and a horizontal adjustment range of 360° in
azimuth.
