Euromate 326232, Монтажный

Страница: 9 / 36

GB
9
Pendant lamp
Safety instructions
•
The light may be installed indoors only.
•
To operate this product safely, the user must have
read and understood these instructions for use
before using the product for the first time.
• Always keep the operating instructions within
reach.
• If you sell or pass on the device, you must also
pass on these operating instructions.
• When working on walls, ceiling or floors, pay
attention to any installed cables as well as gas
and water lines.
• Installation may be carried out only by a suitably
qualified electrical specialist.
• Use only bulbs authorised by the manufacturer.
Do not exceed the maximum bulb power
(
►
Technical data – p. 10 )!
• Use only connection clips authorised by the man-
ufacturer.
• Only use connection cables permitted by the
manufacturer.
• The bulb becomes hot when used! Before chang-
ing the bulb, allow to cool.
Installation
►
Assembly – p. 2
– Loosen the screws in the lamp housing and
remove the holder.
– Drill the holes and insert dowels.
– Screw the holder firmly to the wall or ceiling.
– Connect the mains cable.
– Place the lamp in the holder and screw tight.
Changing the bulb
Cleaning
– Wipe down the device with a dry or damp cloth.
Storage and transport
Storing
– Store the device and any accessories in a dry,
well-ventilated place.
– In case of longer periods without operation, pro-
tect the device and its accessories against soiling
and corrosion.
Transport
– Use the original packaging to ship whenever pos-
sible.
Troubleshooting
If something stops working…
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
If you can’t fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred. Disposal
Disposing of the product
A crossed-out wheelie bin icon means: Bat-
teries and rechargeable batteries, electrical
or electronic devices must not be disposed of
with household waste. They may contain
substances that are harmful to the environ-
ment and human health.
DANGER! Risk of fatal injury due to elec-
tric shock!
Installation may be carried out
only by a suitably qualified electrical special-
ist.
Before installation, it must be ensured that
there is no current to the electrical network
(switch off at main switch or remove fuse).
CAUTION! Danger of being burnt!
The
bulb becomes hot when used! Before chang-
ing the bulb, allow to cool.
NOTICE! Risk of damage to the device!
Do not use any sharp or abrasive objects, or
aggressive cleaning agents.
Do not use cleaning solutions.
DANGER! Danger to life and limb!
Improper repairs can result in the product
functioning unsafely. This endangers your-
self and your environment.
DANGER! Risk of fatal injury due to elec-
tric shock!
All work to eliminate possible
faults should be carried out with the fuse
switched off. All work should be carried out
by a qualified electrician.
Fault/malfunction Cause Remedy
The lamp does not light up No mains voltage? Check fuse. Contact a specialist.
Light source defective? Check illuminant, replace if neces-
sary if possible
Luminaire switched on via switch? Check switch position
Switch defective? Contact a specialist.
Connection cable defective? Contact a specialist.
Incorrect connection? Switch off the fuse and check the
connection according to the wiring
diagram. Contact a specialist.