GB
11
Overheat protection
This heater is protected with an overheat protection
which switches off the heating element automatically
in case of overheat. For example, in the case of total
or partial obstruction of the grids, please wait the
heater to cool down and remove the object obstruct-
ing the grids. Then the thermal cut-out will automati-
cally reset, and heating element can operate nor-
mally.
Should the problem persist, please contact the near-
est customer service.
Remote Control
The remote control requires 1 × CR2025 lithium bat-
tery (not included)
Important: Follow the instructions of use and the recy-
cle rules given on the battery packaging.
– Open the battery compartment by sliding the
cover down.
– Insert the battery into the compartment, observ-
ing the polarity in the diagram (see below draw-
ing).
– Close the battery compartment.
1.
Remote control
2.
Insulating film
3.
Battery carriage
4.
Release Tab
Cleaning
– Switch off the device and let it cool off completely.
– Pull out the plug.
– Wipe the device with a slightly damp cloth.
Faults and remedial measures
When something isn’t working…
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
If you can’t fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
Disposal
Disposal of the appliance
A crossed-out wheelie bin icon means: Bat-
teries and rechargeable batteries, electrical
or electronic devices must not be disposed of
with household waste. They may contain
substances that are harmful to the environ-
ment and human health.
Consumers must dispose of waste electrical devices,
spent portable batteries and rechargeable batteries
separately from household waste at an official collec-
tion point to ensure that these items are processed
correctly. Information on returning these items is
available from the seller. Sellers are required to
accept these items free of charge.
Batteries and rechargeable batteries, which
are not permanently installed in waste elec-
trical devices, must be removed prior to dis-
posal and must be disposed of separately.
Lithium batteries and battery packs in all systems
must only be retuned to a collection point when dis-
charged. Batteries must always be protected against
short circuits by covering the poles with adhesive
tape.
All end users are responsible for deleting any per-
sonal data stored on waste devices prior to their dis-
posal.
Disposal of the packaging
The packaging consists of cardboard and
correspondingly marked plastics that can
be recycled.
– Make these materials available for
recycling.
Technical data
Note:
To assist in maintaining the internal
components, after pressing the
[OFF]
but-
ton the fan will continue to blow room air for
a period of 30-60 seconds before shutting
down to standby mode.
DANGER! Risk of injury!
Before all work
on the device, always disconnect the mains
plug.
DANGER! Risk of injury!
Improperly per-
formed repairs can lead to the device not
functioning safely. This endangers yourself
and your environment.
Fault/malfunction
Cause
Remedial measure
Device does not work or does not
heat
Is the device switched off or set on
ventilation without heat?
Switch on the device or set the de-
sired heat level.
No mains voltage?
Check cable, plug, socket and fuse.
Item number
107447
Nominal voltage
230 V~, 50 Hz
Nominal output
1500 W
Heat levels
800 W
1500 W
Protection class
II
Содержание 107447
