1 / 2
Edition of 04/05/2021
Starting up
Starting up
Mixpro 28
Mixpro 28
- 2021 version
- 2021 version
• Apply silicone spray to the rotor (never use lubricant or grease), screw it into the stator with the propeller as far as it will go. Then
turn the motor a quarter turn in the opposite direction and close it.
• Connect the electric plug, turn the main switch to ON.
• Check that the water pump is not blocked. Unblock it if necessary.
• Check the position of the buttons and the thermal circuit breaker of the compressor.
A
Stop
F
Power on
B
Start / Error acknowledgement
G
Product selection (Powder - Paste)
C
Water rise
H
Compressor start (Manual - Automatic)
D
Speed control
I
Water pump selection (Manual - Off - Automatic)
E
Indicator light
J
Reverse gear
• Connect the water (minimum 2 bars on the network) and prime it: Open the side valve and put the pump in MANUAL position, when
the water comes out without air regularly, close the valve and put the pump button on 0 (or in auto if less than 4 bars on the network)
• Connect the control hose.
•
Open the water flow control valve (loosen 2 turns) and press the water lift button for 5 seconds.
•
Start the machine and let the water flow out of the hose (set the desired water flow). When the water comes out of the hose, turn
off with the remote control. Make sure the machine is running normally.
•
Make an upflow of water (about halfway up the chamber).
•
Connect the product hose to the side outlet and turn on the water to moisten it. When the water comes out, turn off the water and
empty the water from the hose.
• Break 2 bags of product.
• Insert the adjustment hose to adjust the consistency (or perform the operation directly on the product outlet).
• Clean the adjustment hose with the side outlet.
• Install the hose and pole (if equipped)
• Put the machine in AUTOMATIC mode, start it with the remote control and let the product come out of the nozzle.
•
When the product comes out of the lance, cut off by remote control.
• Apply product (machine must always be full)
•
Apply the floor-screed.
A
B
F
I
J
H
G
C
D
E
