20
Wi-Fi and app operation
The heater can also be controlled with an app on your smartphone. To do this, the
heater must be connected to a Wi-Fi modem. To install the app, refer to the end of this
booklet.
Safety feature
In case of internal overheating,
the overheating safeguard
will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in enough
fresh air. As mentioned above, this is generally caused by (partially) covering the heater,
or installing the heater too close to a wall or something similar. In case of overheating,
switch off the heater and unplug. Give the heater time to cool down, remove the source
of the overheating and use as normal. If the problem persists or if you have not been
able to trace the source of the overheating, turn the heater off immediately and unplug.
Contact a servicing point to have the heater repaired.
Cleaning and Maintenance
Keep the heater clean. Switch off the heater, remove the plug from the socket and allow
the heater to cool down before cleaning or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical
solutions; This can cause irreparable scratches and damage! You can use a glass
cleaner for the ‘Verre’ models. Never use cloths that are too wet, dry the appliance
properly and ensure that the entire unit is dry before taking it back into use.
You can keep the back of the heater free of dust with a feather duster. For thorough
cleaning of the back, you can take the heater from the wall.
If you want to store the Mon Soleil at the end of the season, remove it from the wall,
unscrew the suspension frame (if applicable) and store the entire unit (in the original
packaging) upright in a cool, dry and frost-free place.
CE-statement
Eurom - Genemuiden-NL
hereby declares that the
EUROM electrical convector
heater
, type
Mon Soleil wifi 300 / 600 / 350 Verre / 500 Verre / 700 Verre
, complies
with the LVD guideline 2014/35/EU, EMC guideline 2014/30/EU, RED guideline
2014/53/EU and meets the following standards:
LVD 2015/35/EU
EN 60335-1:2012/A11:2014
EN 60335-2-30:2009/A11:2012
EN 62233:2008
EMC 2014/30/EU
EN 55014:2006/A2:2011
EN 55014-2:2015
EN 300 328 V2.1.1 :2016
EN 62311 :2008
Draft ETSI EN 301 489-1 V2.2.0:2017
Draft ETSI EN 301 489-17 V3.2.0:2017
Genemuiden, 11-07-2017
W.J. Bakker, alg.dir.
