En glish
6
Operate the device only after having familiarized with its functions. Do not allow an operation by persons who
do not know the device well enough. Most damages are the result of an unprofessional operation!
Please consider that for safety reasons unauthorized modifications to the device are forbidden!
CONNECTING TO MAINS
Caution! Only qualified staff is allowed to carry out the connection.
The A/C connection cable's green/yellow wire is the earthing conductor. The blue and the green wire carry
the voltage.
INSTALLATION
When installing the device, make sure that the venting slots are not covered by decoration material. In order
to safeguard sufficient ventilation, leave 10 cm of free space around the device.
You can mount the device both on the floor and on the ceiling. Make sure that the inclination angle does not
exceed 10 degrees.
Caution! Ensure a minimum distance between snow machine and audience of min. 2m. Never direct the
snow output nozzle to the face or the eyes of people.
Due to its construction, the nozzle may produce liquid droplets. Consider the dropping of this liquid when
chosing the location for installing the device.
In general, the snow dissolves without leaving any residues. Once in a while, the fluid may leave residues on
the floor or the clothing; these can easily be removed.
Caution! This snow machine is not splash-proofed. Only for inside usage.
If liquids happen to enter the device, immediately disconnect from mains and consult a specialist.
Caution! Never run the device with empty tank. Disconnect from mains before re-fill. Only use fluid
recommended by the manufacturer.
Before you initial start-up, fill the snowfluid tank. Only use high-quality fluids like EUROLITE fluid, because
the pump could be clogged otherwise. Always make sure that the tank is filled sufficiently. Damages caused
by the non-observence of these instructions are not subject to warranty!
OPERATION
Plug the device in and switch the power switch on the rear panel. The device starts running.
Caution! Only adults are allowed to operate this device. Always disconnect from mains or switch off power
switch when not using the device.
Never leave the smoke machine without observation.
Disconnect from mains before opening the housing. There are no serviceable parts inside. The fine-wire fuse
in the fuse box on the rear panel may only be replaced by a fuse of the same value and rating. In case of
malfunction, please consult a specialist.
We hope you will enjoy your snow machine.
TECHNICAL SPECIFICATIONS SNOW 5001:
Power supply:
230 V/50 Hz
Power consumption:
600 W max.
Snow output:
90 ml/min
Tank capacity:
5 litres
Dimensions (LxWxH):
515 x 258 x 220 mm
Weight:
10 kg
Please note: All specifications are subject to change withour prior notice.
10/98
©
Errors and omissions excepted.
